Contents 1 Ardour 2 Pronto: 2.1 Channels 2.2 Presets: 2.3 Masters 2.4 various trouble:

Ardour

The Ardour Cheat Sheet is here: http://ardour.org/node/2894

Pronto:

• Pronto Setup is in, well, [SETUP]
• get help with [?]+[any key you don't know about]
• Menus are accessed with [DownArrow] or [C/ALT]+[DownArrowe] or [UpArrow]; Select with [MODIFY];
• Patch is in [Menu],<Pronto>,<Channels>. See <channel curves> and <channels layout> too.
• Save/Load are in [Menu],<Files>
• Scroll in windows, menus by holding down any [ArrowKey] and moving the [LevelWheel]

Channels

• Set channel 1 manually: [1], Level Wheel
• Set 1 at 50%: [1],[CHannel],[50],[@_level]
• Set 1 at full: [1], [C/ALT]+[+%]
• 2+3 at 50: [2],[CH],[3],[+],[50],[@_LEVEL]
• Set 5>9@50: [5],[CH],[9],[THRU],[@_LEVEL]

• The [ALL] key select all channels with a level
• Bòackout: [C/ALT]+[CHannel]
• [MODIFY]+[CHannel] brings editor of channel parameters, so [1], [MODIFY]+[CHannle] will allow to modify parameters of Channel 1.

All and everything about channels is page 120

Presets:

• record a preset: [1],[RECORD],[modify]
• Crossfade to preset 1: [1],[GOTO]
• Load preset 2 in B register: [2], [PRESET]+[B]
• edit esquence of preset: put preset 5 after 1: [1],[SEQ] then [insert]

• Load, work, arrange sequences of presets in [MENU],<PLAY> and [MENU],<PLAYLIST>.
• Also, hold down 2 secs [A], [B], [C] or [D] to access it and edit

• Bring up the list of presets: [PRESET]
• Blind editing a preset: [1], [PRESET]

• If you are in preset 0, then preset 1 is loaded to B register, just hit [GO]; you can interrupt with [PAUSE], restart with [GO]

• [GO BACK] button goes back in 2 seconds.
• Blackout: [0]+[GOTO]

Masters

• Set Preset to a master: [1], [PRESET]+[master button 1]

-+ Modofy a subgroup: [MODIFY]+[MasterButton] or Hold Down [MasterButton] 2 secs

various trouble:

• [FREEZE] switch upper right does just that, freeze the output.
• always make sure console is not in direct channel, set direct channel switch to off
• check Blackout led, must be Off.
• Crossfade manual faders must be completely down to allow next crossfade to take place by moving from down to up.

Paste = C/Alt & INSERT
Copy = C/Alt & DELETE
Cut = Make a COPY followed by a DELETE